Driveways, walkways, and patios take a beating from weather, moss, and everyday grime. We match the right pressure and technique to the surface — powerful enough to strip years of buildup, gentle enough not to damage it.
Florida's climate is rough on hard surfaces — humidity and shade encourage algae and moss to take hold fast, and everyday tire, foot, and weather traffic grinds dirt into the pores of concrete and pavers over time. Left alone, it doesn't just look bad — it gets slippery and, on some surfaces, starts to stain in permanently.
We assess the surface first — concrete, pavers, brick, and natural stone all respond differently to pressure — then choose the right combination of pressure, cleaning solution, and technique. The result is a deep clean that lifts embedded grime without pitting, etching, or stripping the surface.
Pressure washing suits hard surfaces like concrete driveways, but technique still matters. Pavers need a wide spray at a low angle, because the wrong nozzle or pressure can wash sand out of the joints and roughen the surface, and the joints may need fresh sand after cleaning. A surface cleaner, a pressure washer attachment with a spinning disc, gives an even result on flat concrete and avoids stripes. Our guide to green and black stains on driveways and pavers goes deeper.
Got a letter from your HOA about the driveway or roof? Our one-page plan walks through the steps, and the full guide has the details.
Usually algae, mold, and mildew, which grow wherever moisture and shade linger. Pressure washing can clear them from concrete, and fixing the moisture is what slows the stains from returning.
Read the guide: Green & Black Driveway Stains
Yes, if the pressure is too high, the nozzle is too close, or the technique is wrong. It can wash sand out of the joints and roughen the surface. The Concrete Masonry & Hardscapes Association says a wide-spray nozzle at a low angle reduces the risk of dislodging joint sand.
Read the guide: Green & Black Driveway Stains
Only for necessary maintenance. As of November 10, 2026, the Southwest Florida Water Management District's Modified Phase III restrictions run through March 31, 2027, and its page says annual pressure washing for aesthetic purposes is not allowed. Removing mold or mildew from driveways and sidewalks is allowed. Check your own utility's rules too.
Read the guide: Pressure Washing & Water Shortage
White, chalky spots are usually dissolved minerals such as calcium left behind when sprinkler water dries. Orange or rust-colored streaks are usually iron, which UF/IFAS says is common in Florida well water. Stop the spray from hitting the house, then clean early.
Read the guide: Sprinkler Stains
It depends on your community's documents. Under section 720.305 of the Florida Statutes, an HOA may levy reasonable fines only after at least 14 days' written notice and a chance for a hearing, and no fine or suspension may be imposed if you cure the violation before the hearing. Fines may not exceed $100 per violation unless your documents say otherwise. This is general information, not legal advice.
Read the guide: HOA Letters About Dirty Roofs & Driveways
Co-owner Arthur Smygov maintains the soft wash, windows, roof, and driveway of this home near South Venice. See the photo and how we handle each surface.